diff --git a/config/example-odroidc5.cfg b/config/example-odroidc5.cfg
index 52d6e882..8efce823 100644
--- a/config/example-odroidc5.cfg
+++ b/config/example-odroidc5.cfg
@@ -21,7 +21,7 @@
 serial: /tmp/klipper_host_mcu
 
 [mcu EBBCan] # based on EBB36 CAN V1.1
-canbus_uuid: e8a11afa199b
+canbus_uuid: 1e8ea3b32c8a
 
 [printer]
 kinematics: cartesian
@@ -58,7 +58,7 @@ homing_speed: 50
 
 [stepper_z]
 step_pin: gpiochip0/gpio55
-dir_pin: !gpiochip0/gpio62
+dir_pin: !gpiochip0/gpio54
 enable_pin: !gpiochip0/gpio26
 microsteps: 16
 rotation_distance: 8
@@ -67,23 +67,23 @@ position_min: -4.0
 position_max: 300
 
 [stepper_z1]
-step_pin: gpiochip0/gpio54
+step_pin: gpiochip0/gpio62
 dir_pin: !gpiochip0/gpio40
 enable_pin: !gpiochip0/gpio27
 microsteps: 16
 rotation_distance: 8
 
 [extruder]
-step_pin: EBBCan: PD0
-dir_pin: EBBCan: PD1
-enable_pin: !EBBCan: PD2
+step_pin: EBBCan: PA9
+dir_pin: EBBCan: PA8
+enable_pin: !EBBCan: PA10
 microsteps: 16
 rotation_distance: 7.703694208
 nozzle_diameter: 0.400
 filament_diameter: 1.750
-heater_pin: EBBCan:PB13
+heater_pin: EBBCan:PB1
 sensor_type: EPCOS 100K B57560G104F
-sensor_pin: EBBCan:PA3
+sensor_pin: EBBCan:PA0
 control: pid
 pid_Kp: 21.527
 pid_Ki: 1.063
@@ -159,13 +159,13 @@ hold_current: 0.500
 stealthchop_threshold: 30
 
 [tmc2209 extruder]
-uart_pin: EBBCan:PA15
+uart_pin: EBBCan:PA13
 run_current: 0.800
 hold_current: 0.500
 stealthchop_threshold: 250
 
 [probe]
-pin: !EBBCan:PB8
+pin: !EBBCan:PA5
 x_offset: -42.0
 y_offset: -4.0
 speed: 5.0
@@ -240,4 +240,4 @@ gcode:
 #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
 #*#
 #*# [probe]
-#*# z_offset = 0.34
\ No newline at end of file
+#*# z_offset = 0.34