Kevin O'Connor b2caa486c5 adc_temperature: Support multiple ranges for ADC lookup ...

Instead of supporting a single linear range for the temperature
lookup, allow multiple ranges to be defined.  This makes the lookup
more accurate when a full lookup table is available.

Update the AD595 sensor to use the full table defined in its spec.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2018-04-09 15:06:53 -04:00

..

__init__.py

klippy: Add support for dynamic loading of python modules

2018-01-28 12:19:26 -05:00

ad5206.py

pins: Remove module level get_printer_pins() and setup_pin() functions

2018-04-04 12:26:39 -04:00

adc_temperature.py

adc_temperature: Support multiple ranges for ADC lookup

2018-04-09 15:06:53 -04:00

bed_tilt.py

bed_tilt: Apply bed_tilt_calibrate settings to current session

2018-04-03 13:18:53 -04:00

delta_calibrate.py

probe: Add z_offset parameter

2018-03-17 14:07:15 -04:00

display.py

display: Round temperature and position to nearest whole number

2018-03-19 15:17:53 -04:00

fan.py

pins: Remove module level get_printer_pins() and setup_pin() functions

2018-04-04 12:26:39 -04:00

heater_bed.py

heater: Add PrinterHeaters class that stores all sensors and heaters

2018-04-04 23:13:53 -04:00

heater_fan.py

heater: Add PrinterHeaters class that stores all sensors and heaters

2018-04-04 23:13:53 -04:00

homing_override.py

klippy: Introduce load_config_prefix() for modules that take parameters

2018-02-03 12:53:11 -05:00

multi_pin.py

pins: Remove module level get_printer_pins() and setup_pin() functions

2018-04-04 12:26:39 -04:00

output_pin.py

output_pin: Move pwm and digital output pins to new module in extras/

2018-03-17 13:46:36 -04:00

pid_calibrate.py

pid_calibrate: Make sure to unregister new control class on error

2018-04-06 11:39:24 -04:00

probe.py

probe: Add z_offset parameter

2018-03-17 14:07:15 -04:00

replicape.py

pins: Remove module level get_printer_pins() and setup_pin() functions

2018-04-04 12:26:39 -04:00

servo.py

pins: Remove module level get_printer_pins() and setup_pin() functions

2018-04-04 12:26:39 -04:00

static_digital_output.py

static_digital_output: Add static_digital_output section to extras/

2018-03-17 13:06:51 -04:00

thermistor.py

thermistor: Fallback to using beta if Steinhart-Hart c3 is negative

2018-04-09 12:35:18 -04:00

verify_heater.py

heater: Add PrinterHeaters class that stores all sensors and heaters

2018-04-04 23:13:53 -04:00

virtual_sdcard.py

virtual_sdcard: Fix typo in seek error handling

2018-03-12 22:36:39 -04:00