Kevin O'Connor c3efcd9c8d bus: Set all SPI CS pins high before first config_spi message ...

If an SPI device is shared among many devices, then all the device's
CS pins should be set high prior to setting up the clk pin.
(Otherwise, there's a chance a device could interpret the clk pin
setup as part of a transmission.)

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-01-04 22:26:34 -05:00

..

chelper

winch: Add experimental support for cable winch kinematics

2018-12-24 11:38:59 -05:00

extras

bus: Set all SPI CS pins high before first config_spi message

2019-01-04 22:26:34 -05:00

kinematics

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

clocksync.py

clocksync: Simplify is_active() check

2018-05-31 18:20:30 -04:00

configfile.py

configfile: Strip trailing comments

2018-10-16 11:45:20 -04:00

console.py

console: Try to improve the description of the SUPPRESS command

2018-11-16 17:16:14 -05:00

gcode.py

respond: An extra for sending messages to the printer host. (#1053)

2019-01-02 17:45:35 -05:00

heater.py

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

homing.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

klippy.py

klippy: No need to return anything from _connect() method

2018-10-18 15:58:52 -04:00

mathutil.py

delta_calibrate: Perform coordinate descent in a background process

2018-10-15 19:01:19 -04:00

mcu.py

mcu: Allow set_stepper_kinematics() to set the kinematics back to None

2018-12-24 11:42:13 -05:00

msgproto.py

msgproto: Add support for a get_constant_int() method

2018-05-28 10:43:40 -04:00

parsedump.py

build: Request python2 for all directly executed python binaries

2017-06-27 20:26:02 -04:00

pins.py

bus: Don't raise a "duplicate pin" warning on None pins

2019-01-02 17:37:39 -05:00

queuelogger.py

klippy: Automatically clear rollover_info on each restart

2018-04-03 13:18:52 -04:00

reactor.py

reactor: Add ability to register callbacks

2018-06-30 14:13:47 -04:00

serialhdl.py

serialqueue: Limit message transmission to available receive buffer size

2018-05-28 11:12:30 -04:00

stepper.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

toolhead.py

toolhead: Do not apply main printer accel/velocity to extrude only moves

2019-01-04 12:47:45 -05:00

util.py

util: Fix versioning when gitdir is absent (#809)

2018-10-27 10:44:38 -04:00