The cited commit limited log_max_qp to be 17 due to FW capabilities.
Recently, it turned out that there are old FW versions that supported
more than 17, so the cited commit caused a degradation.
Thus, set the maximum log_max_qp back to 18 as it was before the
cited commit.
Fixes: 7f839965b2 ("net/mlx5: Update log_max_qp value to be 17 at most")
Signed-off-by: Maher Sanalla <msanalla@nvidia.com>
Reviewed-by: Maor Gottlieb <maorg@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
While extending available range of supported chains/prios referenced commit
also modified slow path rules to go to FT chain instead of actual slow FDB.
However neither of existing users of the MLX5_ATTR_FLAG_SLOW_PATH
flag (tunnel encap entries with invalid encap and flows with trap action)
need to match on FT chain. After bridge offload was implemented packets of
such flows can also be matched by bridge priority tables which is
undesirable. Restore slow path flows implementation to redirect packets to
slow_fdb.
Fixes: 278d51f243 ("net/mlx5: E-Switch, Increase number of chains and priorities")
Signed-off-by: Vlad Buslov <vladbu@nvidia.com>
Reviewed-by: Roi Dayan <roid@nvidia.com>
Reviewed-by: Paul Blakey <paulb@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
Before commit 76c31e5f75 ("net/mlx5e: Use FW limitation for max MPW
WQEBBs"), the maximum size of MPWQE in WQEBBs was hardcoded as a driver
constant. That commit started using the firmware capability that can
further limit the size, however, it unintentionally changed a few
things:
1. The calculation of MLX5E_MAX_KLM_PER_WQE used the size in DS, which
was replaced by the size in WQEBBs, making the resulting value 4 times
smaller.
2. MLX5E_TX_MPW_MAX_WQEBBS used to be aligned to the cache line size
(either 64 or 128 bytes, i.e. 1 or 2 WQEBBs), but it's no longer the
case if the firmware capability is smaller than the driver maximum.
Fix both issues by using the correct units for MLX5E_MAX_KLM_PER_WQE and
by aligning mlx5e_get_sw_max_sq_mpw_wqebbs after taking the minimum.
Besides fixing the arithmetics in calculation of MLX5E_MAX_KLM_PER_WQE,
also use appropriate constants: `size of BSF * num of DS per WQEBB *
number of WQEBBs` (the calculation before the blamed commit) doesn't
make much sense to calculate the WQE size in bytes, so just use `size of
WQEBB * number of WQEBBs`.
While at it, replace the types that hold the number of WQEBBs by u8.
These values don't exceed 16, and it allows to fill holes in two
structs.
Fixes: 76c31e5f75 ("net/mlx5e: Use FW limitation for max MPW WQEBBs")
Signed-off-by: Maxim Mikityanskiy <maximmi@nvidia.com>
Reviewed-by: Tariq Toukan <tariqt@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
ICOSQ is used to post UMR WQEs for both regular RQ and XSK RQ. However,
space in ICOSQ is reserved only for the regular RQ, which may cause
ICOSQ overflows when using XSK (the most risk is on activating
channels).
This commit fixes the issue by reserving space for XSK UMR WQEs as well.
As XSK may be enabled without restarting the channel and recreating the
ICOSQ, this space is reserved unconditionally.
Fixes: db05815b36 ("net/mlx5e: Add XSK zero-copy support")
Signed-off-by: Maxim Mikityanskiy <maximmi@nvidia.com>
Reviewed-by: Tariq Toukan <tariqt@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
MLX5E_MAX_RQ_NUM_MTTS should be the maximum value, so that
MLX5_MTT_OCTW(MLX5E_MAX_RQ_NUM_MTTS) fits into u16. The current value of
1 << 17 results in MLX5_MTT_OCTW(1 << 17) = 1 << 16, which doesn't fit
into u16. This commit replaces it with the maximum value that still
fits u16.
Fixes: 73281b78a3 ("net/mlx5e: Derive Striding RQ size from MTU")
Signed-off-by: Maxim Mikityanskiy <maximmi@nvidia.com>
Reviewed-by: Tariq Toukan <tariqt@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
The cited commit changed CT to use multi table actions post act infrastructure instead
of using it own post act infrastructure, this broke decap during VF tunnel offload
(Stack devices) with CT due to wrong match on in_port metadata in the post act table.
This changed only broke VF tunnel offload because it modify the packet in_port metadata
to be VF metadata and it isn't propagate the post act creation.
Fixed by modify post act rules to match only on fte_id and not match on in_port metadata
which isn't needed.
Fixes: a81283263b ("net/mlx5e: Use multi table support for CT and sample actions")
Signed-off-by: Maor Dickman <maord@nvidia.com>
Reviewed-by: Roi Dayan <roid@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
The driver reports whether TX/RX TLS device offloads are supported, but
not which ciphers/versions, these should be handled by returning
-EOPNOTSUPP when .tls_dev_add() is called.
Remove the WARN_ON kernel trace when the driver gets a request to
offload a cipher/version that is not supported as it is expected.
Fixes: d2ead1f360 ("net/mlx5e: Add kTLS TX HW offload support")
Signed-off-by: Gal Pressman <gal@nvidia.com>
Reviewed-by: Tariq Toukan <tariqt@nvidia.com>
Reviewed-by: Maxim Mikityanskiy <maximmi@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
Users may request that pages from an OpenCL SVM allocation be migrated
to the GPU with clEnqueueSVMMigrateMem(). In Nouveau this will call into
nouveau_dmem_migrate_vma() to do the migration. If the total range to be
migrated exceeds SG_MAX_SINGLE_ALLOC the pages will be migrated in
chunks of size SG_MAX_SINGLE_ALLOC. However a typo in updating the
starting address means that only the first chunk will get migrated.
Fix the calculation so that the entire range will get migrated if
possible.
Signed-off-by: Alistair Popple <apopple@nvidia.com>
Fixes: e3d8b08904 ("drm/nouveau/svm: map pages after migration")
Reviewed-by: Ralph Campbell <rcampbell@nvidia.com>
Reviewed-by: Lyude Paul <lyude@redhat.com>
Signed-off-by: Lyude Paul <lyude@redhat.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20220720062745.960701-1-apopple@nvidia.com
Cc: <stable@vger.kernel.org> # v5.8+
mes self test rely on vm mapping, move it after
drm sched re-started so that vm mapping can work
during gpu reset.
Signed-off-by: Jack Xiao <Jack.Xiao@amd.com>
Acked-and-tested-by: Evan Quan <evan.quan@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
This extra call trace dump comes out in every gpu reset.
And it gives people a wrong impression that something
went wrong. Although actually there was not.
Signed-off-by: Evan Quan <evan.quan@amd.com>
Acked-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Instead of listing directly properties typical for SPI peripherals,
reference the spi-peripheral-props.yaml schema. This allows using all
properties typical for SPI-connected devices, even these which device
bindings author did not tried yet.
Remove the spi-* properties which now come via spi-peripheral-props.yaml
schema, except for the cases when device schema adds some constraints
like maximum frequency.
While changing additionalProperties->unevaluatedProperties, put it in
typical place, just before example DTS.a
The binding references also input.yaml and lists explicitly allowed
properties, thus here reference only spi-peripheral-props.yaml for
purpose of documenting the SPI slave device and bringing
spi-max-frequency type validation.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20220727164230.385614-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
All references to struct freesync_context were removed, so remove the
struct freesync_context itself and its entry on struct dc_stream_state.
Reviewed-by: Rodrigo Siqueira <Rodrigo.Siqueira@amd.com>
Signed-off-by: Maíra Canal <mairacanal@riseup.net>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The kgd_mem memory allocated in amdgpu_amdkfd_gpuvm_import_dmabuf()
is not freed properly.
Explicitly free it in amdgpu_amdkfd_gpuvm_free_memory_of_gpu()
under condition "mem->bo->kfd_bo != mem".
Suggested-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Lang Yu <Lang.Yu@amd.com>
Reviewed-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[WHY]
Unified memory with xnack off should be tracked, as userptr mappings
and legacy allocations do. To avoid oversuscribe system memory when
xnack off.
[How]
Exposing functions reserve_mem_limit and unreserve_mem_limit to SVM
API and call them on every prange creation and free.
Signed-off-by: Alex Sierra <alex.sierra@amd.com>
Reviewed-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The "ret" variable needs to be signed for the error handling to work.
Fixes: 2ca97adccd ("drm/amd/display: Add Synaptics Fifo Reset Workaround")
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
