ARM: dts: renesas: Add compatible properties to KSZ9031 Ethernet PHYs

Add compatible values to Ethernet PHY subnodes representing Micrel
KSZ9031 PHYs on RZ/G1 boards. This allows software to identify the PHY
model at any time, regardless of the state of the PHY reset line.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Tested-by: Biju Das <biju.das.jz@bp.renesas.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Link: https://lore.kernel.org/r/ce8ae6b199fa244315a008ae31891a808ca1948d.1631174218.git.geert+renesas@glider.be

arch/arm/boot/dts/iwg20d-q7-common.dtsi

@@ -158,6 +158,8 @@
 	status = "okay";
 
 	phy3: ethernet-phy@3 {
+		compatible = "ethernet-phy-id0022.1622",
+			     "ethernet-phy-ieee802.3-c22";
 		reg = <3>;
 		micrel,led-mode = <1>;
 	};

arch/arm/boot/dts/r8a7742-iwg21d-q7.dts

@@ -175,6 +175,8 @@
 	status = "okay";
 
 	phy3: ethernet-phy@3 {
+		compatible = "ethernet-phy-id0022.1622",
+			     "ethernet-phy-ieee802.3-c22";
 		reg = <3>;
 		micrel,led-mode = <1>;
 	};

arch/arm/boot/dts/r8a7745-iwg22d-sodimm.dts

@@ -123,6 +123,8 @@
 	 * On some older versions of the platform (before R4.0) the phy address
 	 * may be 1 or 3. The address is fixed to 3 for R4.0 onwards.
 	 */
+		compatible = "ethernet-phy-id0022.1622",
+			     "ethernet-phy-ieee802.3-c22";
 		reg = <3>;
 		micrel,led-mode = <1>;
 	};

arch/arm/boot/dts/r8a77470-iwg23s-sbc.dts

@@ -79,6 +79,8 @@
 	status = "okay";
 
 	phy3: ethernet-phy@3 {
+		compatible = "ethernet-phy-id0022.1622",
+			     "ethernet-phy-ieee802.3-c22";
 		reg = <3>;
 		interrupt-parent = <&gpio5>;
 		interrupts = <16 IRQ_TYPE_LEVEL_LOW>;