This patch adds changes:
- to accommodate the new GEM domain for DOORBELLs
- to accommodate the new TTM PL for DOORBELLs
in order to manage doorbell pages as GEM object.
V2: Addressed reviwe comments from Christian
- drop the doorbell changes for pinning/unpinning
- drop the doorbell changes for dma-buf map
- drop the doorbell changes for sgt
- no need to handle TTM_PL_FLAG_CONTIGUOUS for doorbell
- add caching type for doorbell
V3: - Removed unrelated empty line (Christian)
- Add PL_DOORBELL in mem_type_to_domain() as well (Alex)
Cc: Alex Deucher <alexander.deucher@amd.com>
Cc: Christian Koenig <christian.koenig@amd.com>
Reviewed-by: Christian Koenig <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Shashank Sharma <shashank.sharma@amd.com>
SMEM instructions can reach addresses above 47 bits but require
bit 47 to be sign-extended through bits [63:48].
This allows the TMA to be relocated in a following patch.
Signed-off-by: Jay Cornwall <jay.cornwall@amd.com>
Reviewed-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The TBA and TMA, along with an unused IB allocation, reside at low
addresses in the VM address space. A stray VM fault which hits these
pages must be serviced by making their page table entries invalid.
The scheduler depends upon these pages being resident and fails,
preventing a debugger from inspecting the failure state.
By relocating these pages above 47 bits in the VM address space they
can only be reached when bits [63:48] are set to 1. This makes it much
less likely for a misbehaving program to generate accesses to them.
The current placement at VA (PAGE_SIZE*2) is readily hit by a NULL
access with a small offset.
Signed-off-by: Jay Cornwall <jay.cornwall@amd.com>
Reviewed-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Don't set predefined degamma curve to cursor plane if the cursor
attribute flag is not set. Applying a degamma curve to the cursor by
default breaks userspace expectation. Checking the flag before
performing any color transformation prevents too dark cursor gamma in
DCN3+ on many Linux desktop environment (KDE Plasma, GNOME,
wlroots-based, etc.) as reported at:
- https://gitlab.freedesktop.org/drm/amd/-/issues/1513
This is the same approach followed by DCN2 drivers where the issue is
not present.
Fixes: 03f54d7d34 ("drm/amd/display: Add DCN3 DPP")
Link: https://gitlab.freedesktop.org/drm/amd/-/issues/1513
Signed-off-by: Melissa Wen <mwen@igalia.com>
Reviewed-by: Harry Wentland <harry.wentland@amd.com>
Tested-by: Alex Hung <alex.hung@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
For SRIOV VF, FB location is programmed by host driver, no need to
program it in guest driver.
v2: squash in unused variable removal
Signed-off-by: Zhigang Luo <Zhigang.Luo@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Add various functions for replay, such as construct, destroy, enable
get_state, and copy_setting etc. These functions communicate with the
firmware to setup and enable panel replay
Signed-off-by: Bhawanpreet Lakha <Bhawanpreet.Lakha@amd.com>
Reviewed-by: Harry Wentland <harry.wentland@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
For non-GFX IP blocks, set up ras obj if ras feature
is allowed. For GFX IP blocks, force issue ras
enable_feature command to firmware and only set up ras
obj if ras feature is allowed
Signed-off-by: Hawking Zhang <Hawking.Zhang@amd.com>
Reviewed-by: Tao Zhou <tao.zhou1@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Fixes the following:
ERROR: code indent should use tabs where possible
WARNING: Missing a blank line after declarations
WARNING: Prefer 'unsigned int' to bare use of 'unsigned'
WARNING: suspect code indent for conditional statements (8, 24)
+ if (!(data & (DAGB0_CNTL_MISC2__DISABLE_WRREQ_CG_MASK |
[...]
+ *flags |= AMD_CG_SUPPORT_MC_MGCG;
Cc: Christian König <christian.koenig@amd.com>
Cc: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Srinivasan Shanmugam <srinivasan.shanmugam@amd.com>
Reviewed-by: Guchun Chen <guchun.chen@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
For GFX IP that only supports poison consumption, GFX
RAS won't be marked as enabled. i.e., hardware doesn't
support gfx sram ecc. But driver still needs to issue
firmware to enable poison consumption mode for GFX IP.
In such case, check poison mode and treat GFX IP as
RAS capable IP block.
Signed-off-by: Hawking Zhang <Hawking.Zhang@amd.com>
Reviewed-by: Tao Zhou <tao.zhou1@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Some IP blocks only support partial ras feature and don't
have ras counter and/or ras error status register at all.
Driver should not create err_count sysfs node for those
IP blocks.
Signed-off-by: Hawking Zhang <Hawking.Zhang@amd.com>
Reviewed-by: Tao Zhou <tao.zhou1@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
In some instances, the GPU is transmitting repeated frame to the sink
without any updates or changes in the content. These repeat transmission
are wasteful, resulting in power draw in different aspects of the system
1. DCN is fetching the frame of data from DF/UMC/DRAM. This memory traffic
prevents power down of parts of this HW path.
2. GPU is transmitting pixel data to the display through the main link of
the DisplayPort interface. This prevents power down of both the Source
transmitter (TX) and the Sink receiver (RX)
The concepts of utilizing replay is similar to PSR, but there is a benefit of:
Source and Sink remaining synchronized which allows for
- lower latency when switching from replay to live frames
- enable the possibility of more use cases
- easy control of the sink's refresh rate during replay
Due to Source and Sink remaining timing synchronized, Replay can be activated
in more UI scenarios.
Signed-off-by: Bhawanpreet Lakha <Bhawanpreet.Lakha@amd.com>
Reviewed-by: Harry Wentland <harry.wentland@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Fixes the below:
ERROR: switch and case should be at the same indent
WARNING: Prefer 'unsigned int' to bare use of 'unsigned'
WARNING: Block comments use * on subsequent lines
WARNING: Comparisons should place the constant on the right side of the test
Cc: Christian König <christian.koenig@amd.com>
Cc: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Srinivasan Shanmugam <srinivasan.shanmugam@amd.com>
Reviewed-by: Guchun Chen <guchun.chen@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
if GFX clock is in DS (Deep Sleep) state, the current gfx freq may less then dpm
level 0, then pp_dpm_sclk node unable show correct freq.
(align output format with other cards)
Signed-off-by: Yang Wang <kevinyang.wang@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The existing OD interface cannot support the growing demand for more
OD features. We are in the transition to a new OD mechanism. So,
disable the SMU13 OD feature support temporarily. And this should be
reverted when the new OD mechanism online.
Signed-off-by: Evan Quan <evan.quan@amd.com>
Reviewed-by: Guchun Chen <guchun.chen@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
DMA address reference within svm_ranges should be unmapped only after
the memory has been released from the system. In case of range
splitting, the DMA address information should be copied to the
corresponding range after this has split. But leaving dma mapping
intact.
Signed-off-by: Alex Sierra <alex.sierra@amd.com>
Reviewed-by: Felix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Add initial support for IH 6.1.
v2: Fix copyright date (Alex)
Signed-off-by: Ben Li <ben.li@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
On PSP v13.x ASICs, boot loader will set only the MSB to 1 and clear the
least significant bits for any command submission. Hence match against
the exact register value, otherwise a register value of all 0xFFs also
could falsely indicate that boot loader is ready. Also, from PSP v13.0.6
and newer, bits[7:0] will be used to indicate command error status.
Signed-off-by: Lijo Lazar <lijo.lazar@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Driver Changes:
- Avoid infinite GPU waits by avoidin premature release of request's
reusable memory (Chris, Janusz)
- Expose RPS thresholds in sysfs (Tvrtko)
- Apply GuC SLPC min frequency softlimit correctly (Vinay)
- Restore SLPC efficient freq earlier (Vinay)
- Consider OA buffer boundary when zeroing out reports (Umesh)
- Extend Wa_14015795083 to TGL, RKL, DG1 and ADL (Matt R)
- Fix context workarounds with non-masked regs on MTL/DG2 (Lucas)
- Enable the CCS_FLUSH bit in the pipe control and in the CS for MTL+ (Andi)
- Update MTL workarounds 14018778641, 22016122933 (Tejas, Zhanjun)
- Ensure memory quiesced before AUX CCS invalidation (Jonathan)
- Add a gsc_info debugfs (Daniele)
- Invalidate the TLBs on each GT on multi-GT device (Chris)
- Fix a VMA UAF for multi-gt platform (Nirmoy)
- Do not use stolen on MTL due to HW bug (Nirmoy)
- Check HuC and GuC version compatibility on MTL (Daniele)
- Dump perf_limit_reasons for slow GuC init debug (Vinay)
- Replace kmap() with kmap_local_page() (Sumitra, Ira)
- Add sentinel to xehp_oa_b_counters for KASAN (Andrzej)
- Add the gen12_needs_ccs_aux_inv helper (Andi)
- Fixes and updates for GSC memory allocation (Daniele)
- Fix one wrong caching mode enum usage (Tvrtko)
- Fixes for GSC wakeref (Alan)
- Static checker fixes (Harshit, Arnd, Dan, Cristophe, David, Andi)
- Rename flags with bit_group_X according to the datasheet (Andi)
- Use direct alias for i915 in requests (Andrzej)
- Replace i915->gt0 with to_gt(i915) (Andi)
- Use the i915_vma_flush_writes helper (Tvrtko)
- Selftest improvements (Alan)
- Remove dead code (Tvrtko)
Signed-off-by: Dave Airlie <airlied@redhat.com>
# Conflicts:
# drivers/gpu/drm/i915/gt/uc/intel_gsc_fw.c
From: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/ZMy6kDd9npweR4uy@jlahtine-mobl.ger.corp.intel.com
