If the earlycon parameter is given twice, the kernel will spit out a
WARN() in register_console() because it was already registered. The
non-dt variant setup_earlycon() already handles that gracefully. The dt
variant of_setup_earlycon() doesn't. Add the check there and add the
-EALREADY handling in early_init_dt_scan_chosen_stdout().
FWIW, this doesn't happen if CONFIG_ACPI_SPCR_TABLE is set. In that case
the registration is delayed until after earlycon parameter(s) are
parsed.
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Michael Walle <michael@walle.cc>
Link: https://lore.kernel.org/r/20220628120705.200617-1-michael@walle.cc
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Regarding Exynos Auto v9 SoC, it supports uarts up to 12. However, the
maximum number of the ports has been derived from
CONFIG_SERIAL_SAMSUNG_UARTS and tightly coupled with the config for
previous Samsung SoCs such as s3c24xx and s3c64xx. To overcome this
limitation, this changes the usage of the definition to UART_NR which is
widely used from other serial drivers. This also defines the value to 12
only for ARM64 SoCs to not affect the change to previous arm32 SoCs.
Instead of enumerating all the ports as predefined arrays, this
introduces s3c24xx_serial_init_port_default that is initializing the
structure as the default value.
Reviewed-by: Hector Martin <marcan@marcan.st>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Chanho Park <chanho61.park@samsung.com>
Link: https://lore.kernel.org/r/20220629005538.60132-1-chanho61.park@samsung.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Add support for RS-485 multipoint addressing using 9th bit [*]. The
addressing mode is configured through ->rs485_config().
ADDRB in termios indicates 9th bit addressing mode is enabled. In this
mode, 9th bit is used to indicate an address (byte) within the
communication line. ADDRB can only be enabled/disabled through
->rs485_config() that is also responsible for setting the destination and
receiver (filter) addresses.
Add traps to detect unwanted changes to struct serial_rs485 layout using
static_assert().
[*] Technically, RS485 is just an electronic spec and does not itself
specify the 9th bit addressing mode but 9th bit seems at least
"semi-standard" way to do addressing with RS485.
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Link: https://lore.kernel.org/r/20220624204210.11112-6-ilpo.jarvinen@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Use 32-bit reads in order to not lose higher bits of DW UART regs. This
change does not fix any known issue as the high bits are not used for
anything related to 8250 driver (dw8250_readl_ext and dw8250_writel_ext
used within the dwlib are already doing
readl/writel/ioread32be/iowrite32be anyway).
This change is necessary to enables 9th bit address mode. DW UART
reports address frames with BIT(8) of LSR.
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Link: https://lore.kernel.org/r/20220624204210.11112-4-ilpo.jarvinen@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Since commit 31f6bd7fad ("serial: Store character timing information
to uart_port"), per frame timing information is available on uart_port.
Uart port's timeout can be derived from frame_time by multiplying with
fifosize.
Most callers of uart_poll_timeout are not made under port's lock. To be
on the safe side, make sure frame_time is only accessed once. As
fifo_size is effectively a constant, it shouldn't cause any issues.
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Link: https://lore.kernel.org/r/20220613113905.22962-1-ilpo.jarvinen@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The function uses too vague variable names like i, j, k for iterators, p,
q, p1, p2 for pointers etc.
Rename all these, so that it is clear what is going on:
- dict: for dictionaries.
- d, r, g: for dir, row, glyph iterators -- these are unsigned now.
- dir, row: for directory and row pointers.
- glyph: for the glyph.
- and so on...
This is a lot of shuffling, but the result pays off, IMO.
Reviewed-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Signed-off-by: Jiri Slaby <jslaby@suse.cz>
Link: https://lore.kernel.org/r/20220614090537.15557-4-jslaby@suse.cz
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Pull x86 fixes from Thomas Gleixner:
- Make RESERVE_BRK() work again with older binutils. The recent
'simplification' broke that.
- Make early #VE handling increment RIP when successful.
- Make the #VE code consistent vs. the RIP adjustments and add
comments.
- Handle load_unaligned_zeropad() across page boundaries correctly in
#VE when the second page is shared.
* tag 'x86-urgent-2022-06-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
x86/tdx: Handle load_unaligned_zeropad() page-cross to a shared page
x86/tdx: Clarify RIP adjustments in #VE handler
x86/tdx: Fix early #VE handling
x86/mm: Fix RESERVE_BRK() for older binutils
Pull build tooling updates from Thomas Gleixner:
- Remove obsolete CONFIG_X86_SMAP reference from objtool
- Fix overlapping text section failures in faddr2line for real
- Remove OBJECT_FILES_NON_STANDARD usage from x86 ftrace and replace it
with finegrained annotations so objtool can validate that code
correctly.
* tag 'objtool-urgent-2022-06-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
x86/ftrace: Remove OBJECT_FILES_NON_STANDARD usage
faddr2line: Fix overlapping text section failures, the sequel
objtool: Fix obsolete reference to CONFIG_X86_SMAP
Pull scheduler fix from Thomas Gleixner:
"A single scheduler fix plugging a race between sched_setscheduler()
and balance_push().
sched_setscheduler() spliced the balance callbacks accross a lock
break which makes it possible for an interleaving schedule() to
observe an empty list"
* tag 'sched-urgent-2022-06-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
sched: Fix balance_push() vs __sched_setscheduler()
Pull lockdep fix from Thomas Gleixner:
"A RT fix for lockdep.
lockdep invokes prandom_u32() to create cookies. This worked until
prandom_u32() was switched to the real random generator, which takes a
spinlock for extraction, which does not work on RT when invoked from
atomic contexts.
lockdep has no requirement for real random numbers and it turns out
sched_clock() is good enough to create the cookie. That works
everywhere and is faster"
* tag 'locking-urgent-2022-06-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
locking/lockdep: Use sched_clock() for random numbers
Pull irq fixes from Thomas Gleixner:
"A set of interrupt subsystem updates:
Core:
- Ensure runtime power management for chained interrupts
Drivers:
- A collection of OF node refcount fixes
- Unbreak MIPS uniprocessor builds
- Fix xilinx interrupt controller Kconfig dependencies
- Add a missing compatible string to the Uniphier driver"
* tag 'irq-urgent-2022-06-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
irqchip/loongson-liointc: Use architecture register to get coreid
irqchip/uniphier-aidet: Add compatible string for NX1 SoC
dt-bindings: interrupt-controller/uniphier-aidet: Add bindings for NX1 SoC
irqchip/realtek-rtl: Fix refcount leak in map_interrupts
irqchip/gic-v3: Fix refcount leak in gic_populate_ppi_partitions
irqchip/gic-v3: Fix error handling in gic_populate_ppi_partitions
irqchip/apple-aic: Fix refcount leak in aic_of_ic_init
irqchip/apple-aic: Fix refcount leak in build_fiq_affinity
irqchip/gic/realview: Fix refcount leak in realview_gic_of_init
irqchip/xilinx: Remove microblaze+zynq dependency
genirq: PM: Use runtime PM for chained interrupts
Pull char/misc driver fixes for real from Greg KH:
"Let's tag the proper branch this time...
Here are some small char/misc driver fixes for 5.19-rc3 that resolve
some reported issues.
They include:
- mei driver fixes
- comedi driver fix
- rtsx build warning fix
- fsl-mc-bus driver fix
All of these have been in linux-next for a while with no reported
issues"
This is what the merge in commit f0ec9c65a8 _should_ have merged, but
Greg fat-fingered the pull request and I got some small changes from
linux-next instead there. Credit to Nathan Chancellor for eagle-eyes.
Link: https://lore.kernel.org/all/Yqywy+Md2AfGDu8v@dev-arch.thelio-3990X/
* tag 'char-misc-5.19-rc3-take2' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc:
bus: fsl-mc-bus: fix KASAN use-after-free in fsl_mc_bus_remove()
mei: me: add raptor lake point S DID
mei: hbm: drop capability response on early shutdown
mei: me: set internal pg flag to off on hardware reset
misc: rtsx: Fix clang -Wsometimes-uninitialized in rts5261_init_from_hw()
comedi: vmk80xx: fix expression for tx buffer size
