This adds support for rk3288-miniarm board,
Rockchip RK3288 based development boards.
Change-Id: I3db8f16ae7fa5e18675eefb29684f6ef07434683
Signed-off-by: Nickey Yang <nickey.yang@rock-chips.com>
Big cores' power consumption and gpu's are greatly reduced, ipa parameters
are ajusted accordingly.
Change-Id: Ibfdae1856c2f1c2cf80a0a2f963ec878053c6ef0
Signed-off-by: Rocky Hao <rocky.hao@rock-chips.com>
Some evb3 need 1v for 800M.
We remove 700M currently since havn't a good opinion of it.
Change-Id: I7083857f5bb8a09efe0369a6bdd49e28c67da8b7
Signed-off-by: Jianqun Xu <jay.xu@rock-chips.com>
We found that the suspend process was blocked when it run into
ehci/ohci module due to clk-480m of usb2-phy was disabled.
The root cause is that usb2-phy suspended earlier than ehci/ohci
(usb2-phy will be auto suspended if no devices plug-in). and the
clk-480m provided by it was diabled if no module used. However,
some suspend process related ehci/ohci are base on this clock,
so we should refer it into ehci/ohci driver to prevent this case.
Change-Id: Ic5e70a4234382e5cd1e1690e5174891e89360741
Signed-off-by: Frank Wang <frank.wang@rock-chips.com>
Update version to v7.0, main features:
1. new algorithm which is independent of time calculation in almost case,
2. remove charger detect to driver: rk818-charger.c;
3. save algorithm calculation rest value for next system power on calculation;
4. recognize system halt and reset dsoc as rsoc;
5. support hardware sample resistor selected as 10mR or 20mR;
6. optimize zero algorithm to make discharge figure more smooth;
7. fix some logic bugs.
Change-Id: I789d070693ac16102ecbe813d878a2a3c256c030
Signed-off-by: Jianhong Chen <chenjh@rock-chips.com>
Make dts files in order as follows:
rk3399.dtsi
rk3399-box.dtsi
rk3399-box-rev1.dts
rk3399-box-rev2.dts
...
Change-Id: I93d1fb4380d0c84a14fc3476b7435b1abe4989d2
Signed-off-by: Jianqun Xu <jay.xu@rock-chips.com>
fix up the warning:
Line 246: rate_table->nf = nf_out;
drivers/clk/rockchip/clk-pll.c:246:19: warning: 'nf_out' may be used uninitialized in this function [-Wmaybe-uninitialized]
Change-Id: I6c11bf91a280f324c21214cb7839e36f9ffa0da3
Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com>
Due to refer to incorrect diagram, the bits of theXpll_aclk_perihp_src
and Xpll_aclk_emmc_src are incorrect, let's fix them.
Change-Id: I1054d172c8a1897da16287a01bfc5d83126d9666
Signed-off-by: Xing Zheng <zhengxing@rock-chips.com>
Arm64 dma-mapping will return dummy_dma_ops if none call arch_setup_dma_ops
at device creation time.
For ion APIS, ion_pages_sync_for_device and ion_pages_sync_for_cpu always
pass "NULL" as device, then dma-mapping return dummy_dma_ops, which cause
ion pages fail to sync.
This patch fixs __generic_dma_ops to return swiotlb_dma_ops instead of
dummy_dma_ops.
Change-Id: Ic00db5d4547bcd5f74e5fd155133fde408a05cdb
Signed-off-by: Jianqun Xu <jay.xu@rock-chips.com>
set pll sequence:
->set pll to slow mode or other plls
->set pll down
->set pll params
->set pll up
->wait pll lock status
->set pll to normal mode
To slove the system error:
rockchip_rk3399_wait_pll_lock: timeout waiting for pll to lock
rockchip_rk3399_pll_set_params: pll update unsucessful,
trying to restore old params
Change-Id: I62aecd9f292de5a3c7bcd8a87231785bf115159d
Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com>
If setting freq is not support in rockchip_pll_rate_table rk3399_pll_rates[],
It can set pll params by auto.
Change-Id: I5016cece64dca4c2efec18d552ee6be426f6b95a
Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com>
enable CONFIG_NETFILTER_XT_MATCH_QUOTA2_LOG and CONFIG_UID_CPUTIME
Change-Id: I1db112c2ead7fdffaefe5e0e6dfa5800574d6f13
Signed-off-by: Huang, Tao <huangtao@rock-chips.com>
* linux-linaro-lsk-v4.4-android:
Linux 4.4.15
usb: dwc3: exynos: Fix deferred probing storm.
usb: host: ehci-tegra: Grab the correct UTMI pads reset
usb: gadget: fix spinlock dead lock in gadgetfs
USB: mos7720: delete parport
xhci: Fix handling timeouted commands on hosts in weird states.
USB: xhci: Add broken streams quirk for Frescologic device id 1009
usb: xhci-plat: properly handle probe deferral for devm_clk_get()
xhci: Cleanup only when releasing primary hcd
usb: musb: host: correct cppi dma channel for isoch transfer
usb: musb: Ensure rx reinit occurs for shared_fifo endpoints
usb: musb: Stop bulk endpoint while queue is rotated
usb: musb: only restore devctl when session was set in backup
usb: quirks: Add no-lpm quirk for Acer C120 LED Projector
usb: quirks: Fix sorting
USB: uas: Fix slave queue_depth not being set
crypto: user - re-add size check for CRYPTO_MSG_GETALG
crypto: ux500 - memmove the right size
crypto: vmx - Increase priority of aes-cbc cipher
AX.25: Close socket connection on session completion
bpf: try harder on clones when writing into skb
net: alx: Work around the DMA RX overflow issue
net: macb: fix default configuration for GMAC on AT91
neigh: Explicitly declare RCU-bh read side critical section in neigh_xmit()
bpf, perf: delay release of BPF prog after grace period
sock_diag: do not broadcast raw socket destruction
Bridge: Fix ipv6 mc snooping if bridge has no ipv6 address
ipmr/ip6mr: Initialize the last assert time of mfc entries.
netem: fix a use after free
esp: Fix ESN generation under UDP encapsulation
sit: correct IP protocol used in ipip6_err
net: Don't forget pr_fmt on net_dbg_ratelimited for CONFIG_DYNAMIC_DEBUG
net_sched: fix pfifo_head_drop behavior vs backlog
sdcardfs: Truncate packages_gid.list on overflow
UPSTREAM: cdc_ncm: do not call usbnet_link_change from cdc_ncm_bind
BACKPORT: proc: add /proc/<pid>/timerslack_ns interface
BACKPORT: timer: convert timer_slack_ns from unsigned long to u64
netfilter: xt_quota2: make quota2_log work well
Revert "usb: gadget: prevent change of Host MAC address of 'usb0' interface"
BACKPORT: PM / sleep: Go direct_complete if driver has no callbacks
ANDROID: base-cfg: enable UID_CPUTIME
UPSTREAM: USB: usbfs: fix potential infoleak in devio
UPSTREAM: ALSA: timer: Fix leak in events via snd_timer_user_ccallback
UPSTREAM: ALSA: timer: Fix leak in events via snd_timer_user_tinterrupt
UPSTREAM: ALSA: timer: Fix leak in SNDRV_TIMER_IOCTL_PARAMS
ANDROID: configs: remove unused configs
ANDROID: cpu: send KOBJ_ONLINE event when enabling cpus
ANDROID: dm verity fec: initialize recursion level
ANDROID: dm verity fec: fix RS block calculation
The rk818 and rk808 have different way to shutdown.
Add callback(pm_shutdown) to fulfill the individual action for
each PMIC.
Change-Id: I05dc7015ffd0f82c0ab761a380865338fe1adefe
Signed-off-by: Shengfei xu <xsf@rock-chips.com>
Before this revision, if IOMMU isn't enable, driver don't
set the HW running mode to none, it will effect next task
to select its required mode properly.
Change-Id: Ib4e7f23b2014813226bef994aee10b1be8a06634
Signed-off-by: Alpha Lin <alpha.lin@rock-chips.com>
lp8752 static power is too high when in foce pwm mode,
change it's mode to auto.
Change-Id: I6b1342cc8b63d240d90194b52f5926501ea7babf
Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com>
since the commit (878fd85 ARM64: dts: rk3399: lcd_en control in vop),
the panel should enable the backlight gpio by itself.
Change-Id: Ia4128aee0dac4283d359714859662a86667efa27
Signed-off-by: Mark Yao <mark.yao@rock-chips.com>
Add host-port dt config and remove the old ones to support the
new usb2phy driver. Plus, Add vcc5v0_host regulator for usb2phy
and enable host-port config for all rk3399 board.
Change-Id: Ia9d00525f53e5a6f52ca6681b4b6b98235822940
Signed-off-by: Frank Wang <frank.wang@rock-chips.com>
For rk3366 and rk3399, the usb-phy IP block is different than
previous chips, so we should use a new driver to handle them.
Change-Id: I44ebe883664e9fb2fce8707bab2d9159c546e51f
Signed-off-by: Frank Wang <frank.wang@rock-chips.com>
Add to support RK3399 evb reversion 3, with ES2.
Change-Id: Ia07a19d600a6acc1e503e9e56c78d2f60f4ef9be
Signed-off-by: Jianqun Xu <jay.xu@rock-chips.com>
This makes both the usb_otg and usb_host port work well on the RK3288-Fennec board.
Change-Id: I08d2f8916ee1efafdab519513df7cc8e587be2f2
Signed-off-by: Nickey Yang <nickey.yang@rock-chips.com>
due to a merge mistake in I3b80a31681765836a134812ebc56686324ca5194.
Change-Id: Iad2914518997b664704f2c2933c8327fc4252bbb
Signed-off-by: Jeffy Chen <jeffy.chen@rock-chips.com>
Add cru and pmucru regs dump when system panic.
It's just for debug.
Change-Id: I3f837f2941054129d20c2355d86f575d6ee84665
Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com>
This patch add otg-port support. For now, however,
it only support BC1.2 charger detect, power management,
and hold a wakelock when work as SDP(e.g. connect to PC),
and it need to implement otg device/host switch in future.
Change-Id: Ib58aef748211f947da439ebe59fa5cf8dc1fa010
Signed-off-by: Wu Liang feng <wulf@rock-chips.com>
We want add display support on loader, share the same timing
with kernel side, but the timing is hide into kernel code,
can't be share, avoid config twice display timing, add device-tree
display timing support would be good idea.
With this patch, loader and kernel can share same timing from
device node.
Cc: Thierry Reding <thierry.reding@gmail.com>
Change-Id: I6c1ee6ad0194e242035e2f11589d86fdb363b80a
Signed-off-by: Mark Yao <mark.yao@rock-chips.com>
(am from https://patchwork.kernel.org/patch/9238727)
