For this bug, there are two capture pcm streams active, with one
stream and its related stream tag released before suspend. Later
when system suspend is done, the stream tag for the remaining
active stream is released by SOF driver. After system resume, hda
codec driver restores the stream tag for the active pcm stream,
but SOF goes to assign a new one, which now doesn't match with the
stream tag used by codec driver, and this causes DMA to fail
receiving data, leading to unrecoverable XRUN condition in FW.
For stream tag is stored in both hda codec and SOF driver, it
shouldn't be released only in SOF driver. This patch just keeps the
stream information in dma data and checks whether there is a stored
DMA data for stream resuming from S3 and restores it. And it also
removes DMA data when the stream is released.
Tested on Whiskey Lake platform.
GitHub issue: https://github.com/thesofproject/sof/issues/1594
Signed-off-by: Rander Wang <rander.wang@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20190722141402.7194-19-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
In commit 7d4f606c50 ("ALSA: hda - WAKEEN feature enabling for
runtime pm"), legacy HD-A driver sets hda controller in reset mode after
entering runtime-suspend. And when resuming from suspend mode, it checks
hda controller & codec status to detect headphone hotplug event. Now
this patch does the same job in SOF runtime pm functions.
And we need to check all the non-hdmi codecs for some cases like playback
with HDMI or capture with DMIC connected to dsp. In these cases, only
controller is active and codecs are suspended, so codecs can't send
unsolicited event to controller. The jack polling operation will activate
codecs and unsolicited event can work even codecs become suspended later.
Tested on whiskylake with hda codecs.
Signed-off-by: Rander Wang <rander.wang@linux.intel.com>
Signed-off-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20190722141402.7194-13-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
FW encapsulates information about section types (e.g DRAM, IRAM)
inside module block header. This information can be used in order
to correctly load the section to the appropriate place in memory.
SOF Linux driver needs to know for each platform how to map the
section type with the corresponding memory BAR. So, this patch
introduces get_bar_index, a new operation inside snd_sof_dsp_ops.
Intel platforms, usually load all the section in a contiguous memory
area (usually denoted by sdev->mmio_bar) so things are relatively
simple there. Anyhow, on i.MX8 IRAM and DRAM for example are mapped
to distinct BARs.
By default, if no get_bar function is provided the core implementation
will always return sdev->mmio_bar so that there will be no need for
a change to existing Intel code.
Signed-off-by: Daniel Baluta <daniel.baluta@nxp.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20190722141402.7194-7-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
When application goes through SUSPEND/STOP->PREPARE->START
cycle, we should always reprogram the SOF device to start
DMA from a known state so that hw_ptr/appl_ptrs remain valid.
This is expected by ALSA core as it resets the buffer
state as part of prepare (see snd_pcm_do_prepare()).
Fix the issue by forcing reconfiguration of the FW with
STREAM_PCM_PARAMS in prepare(). Use combined logic to handle
prepare and the existing flow to reprogram hw-params after
system suspend.
Without the fix, first call to pcm pointer() will return
an invalid hw_ptr and application may immediately observe XRUN
status, unless "start_threshold" SW parameter is set to maximum
value by the application.
Signed-off-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20190722141402.7194-3-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
VAG power control is improved to fit the manual [1]. This patch fixes as
minimum one bug: if customer muxes Headphone to Line-In right after boot,
the VAG power remains off that leads to poor sound quality from line-in.
I.e. after boot:
- Connect sound source to Line-In jack;
- Connect headphone to HP jack;
- Run following commands:
$ amixer set 'Headphone' 80%
$ amixer set 'Headphone Mux' LINE_IN
Change VAG power on/off control according to the following algorithm:
- turn VAG power ON on the 1st incoming event.
- keep it ON if there is any active VAG consumer (ADC/DAC/HP/Line-In).
- turn VAG power OFF when there is the latest consumer's pre-down event
come.
- always delay after VAG power OFF to avoid pop.
- delay after VAG power ON if the initiative consumer is Line-In, this
prevents pop during line-in muxing.
According to the data sheet [1], to avoid any pops/clicks,
the outputs should be muted during input/output
routing changes.
[1] https://www.nxp.com/docs/en/data-sheet/SGTL5000.pdf
Cc: stable@vger.kernel.org
Fixes: 9b34e6cc3b ("ASoC: Add Freescale SGTL5000 codec support")
Signed-off-by: Oleksandr Suvorov <oleksandr.suvorov@toradex.com>
Reviewed-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Reviewed-by: Fabio Estevam <festevam@gmail.com>
Reviewed-by: Cezary Rojewski <cezary.rojewski@intel.com>
Link: https://lore.kernel.org/r/20190719100524.23300-3-oleksandr.suvorov@toradex.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch fixes below issues reported by coccicheck
sound/soc/bcm/cygnus-pcm.c:642:5-8: Unneeded variable: "ret". Return "0"
on line 650
sound/soc/bcm/cygnus-pcm.c:671:5-8: Unneeded variable: "ret". Return "0"
on line 696
We cannot change return type of these functions as they are callback
functions of snd_pcm_ops
Signed-off-by: Hariprasad Kelam <hariprasad.kelam@gmail.com>
Link: https://lore.kernel.org/r/20190709184236.GA7873@hari-Inspiron-1545
Signed-off-by: Mark Brown <broonie@kernel.org>
snd_hdac_ext_bus_device_exit() has been recently modified
to no longer free the hdac device. SOF allocates memory for
hdac_device and hda_hda_priv with kzalloc. Make them
device-managed instead so that they will be freed when the
SOF driver is unloaded.
Because of the above change, hda_codec is device-managed and
it will be freed when the ASoC device is removed. Freeing
the codec in snd_hda_codec_dev_release() leads to kernel
panic while unloading and reloading the ASoC driver. So,
avoid freeing the hda_codec for ASoC driver. This is done in
the same patch to avoid bisect failure.
Signed-off-by: Libin Yang <libin.yang@intel.com>
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Takashi Iwai <tiwai@suse.de>
Link: https://lore.kernel.org/r/20190626070450.7229-1-ranjani.sridharan@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Pull Devicetree fixes from Rob Herring:
"Fix several warnings/errors in validation of binding schemas"
* tag 'devicetree-fixes-for-5.3' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux:
dt-bindings: pinctrl: stm32: Fix missing 'clocks' property in examples
dt-bindings: iio: ad7124: Fix dtc warnings in example
dt-bindings: iio: avia-hx711: Fix avdd-supply typo in example
dt-bindings: pinctrl: aspeed: Fix AST2500 example errors
dt-bindings: pinctrl: aspeed: Fix 'compatible' schema errors
dt-bindings: riscv: Limit cpus schema to only check RiscV 'cpu' nodes
dt-bindings: Ensure child nodes are of type 'object'
Pull vfs documentation typo fix from Al Viro.
* 'work.misc' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs:
typo fix: it's d_make_root, not d_make_inode...
Pull cifs fixes from Steve French:
"Two fixes for stable, one that had dependency on earlier patch in this
merge window and can now go in, and a perf improvement in SMB3 open"
* tag '5.3-smb3-fixes' of git://git.samba.org/sfrench/cifs-2.6:
cifs: update internal module number
cifs: flush before set-info if we have writeable handles
smb3: optimize open to not send query file internal info
cifs: copy_file_range needs to strip setuid bits and update timestamps
CIFS: fix deadlock in cached root handling
