While interpreting CC_STATUS, ROLE_CONTROL has to be read to make
sure that CC1/CC2 is not forced presenting Rp/Rd.
>From the TCPCI spec:
4.4.5.2 ROLE_CONTROL (Normative):
The TCPM shall write B6 (DRP) = 0b and B3..0 (CC1/CC2) if it wishes
to control the Rp/Rd directly instead of having the TCPC perform
DRP toggling autonomously. When controlling Rp/Rd directly, the
TCPM writes to B3..0 (CC1/CC2) each time it wishes to change the
CC1/CC2 values. This control is used for TCPM-TCPC implementing
Source or Sink only as well as when a connection has been detected
via DRP toggling but the TCPM wishes to attempt Try.Src or Try.Snk.
Table 4-22. CC_STATUS Register Definition:
If (ROLE_CONTROL.CC1 = Rd) or ConnectResult=1)
00b: SNK.Open (Below maximum vRa)
01b: SNK.Default (Above minimum vRd-Connect)
10b: SNK.Power1.5 (Above minimum vRd-Connect) Detects Rp-1.5A
11b: SNK.Power3.0 (Above minimum vRd-Connect) Detects Rp-3.0A
If (ROLE_CONTROL.CC2=Rd) or (ConnectResult=1)
00b: SNK.Open (Below maximum vRa)
01b: SNK.Default (Above minimum vRd-Connect)
10b: SNK.Power1.5 (Above minimum vRd-Connect) Detects Rp 1.5A
11b: SNK.Power3.0 (Above minimum vRd-Connect) Detects Rp 3.0A
Fixes: 74e656d6b0 ("staging: typec: Type-C Port Controller Interface driver (tcpci)")
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Badhri Jagan Sridharan <badhri@google.com>
Link: https://lore.kernel.org/r/20210304070931.1947316-1-badhri@google.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
In USB2 Spec:
"11.18.5 TT Response Generation
In general, there will be two (or more) complete-split
transactions scheduled for a periodic endpoint.
However, for interrupt endpoints, the maximum size of
the full-/low-speed transaction guarantees that it can
never require more than two complete-split transactions.
Two complete-split transactions are only required
when the transaction spans a microframe boundary."
Due to the maxp is 64, and less then 188 (at most in one
microframe), seems never span boundary, so use only one CS
for FS/LS interrupt transfer, this will save some bandwidth.
Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
Link: https://lore.kernel.org/r/5b9ff09f53d23cf9e5c5437db4ffc18b798bf60c.1615170625.git.chunfeng.yun@mediatek.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Currently the null check logic on dwc->usb_psy is inverted as it allows
calls to power_supply_put with a null dwc->usb_psy causing a null
pointer dereference. Fix this by removing the ! operator.
Addresses-Coverity: ("Dereference after null check")
Fixes: 59fa3def35de ("usb: dwc3: add a power supply for current control")
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Link: https://lore.kernel.org/r/20210303095826.6143-1-colin.king@canonical.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
There is no need to keep the dentry pointer around for the created
debugfs file, as it is only needed when removing it from the system.
When it is to be removed, ask debugfs itself for the pointer, to save on
storage and make things a bit simpler.
And, no one noticed that a __maybe_unused dentry * in uhci_start()
really was unused, so remove that as it's obviously not needed, and
hasn't been for quite some time.
Cc: Alan Stern <stern@rowland.harvard.edu>
Cc: linux-usb@vger.kernel.org
Link: https://lore.kernel.org/r/20210216144645.3813043-4-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
When vbus auto discharge is enabled, TCPM can sometimes be faster than
the TCPC i.e. TCPM can go ahead and move the port to unattached state
(involves disabling vbus auto discharge) before TCPC could effectively
discharge vbus to VSAFE0V. This leaves vbus with residual charge and
increases the decay time which prevents tsafe0v from being met.
This change makes TCPM waits for a maximum of tSafe0V(max) for vbus
to discharge to VSAFE0V before transitioning to unattached state
and re-enable toggling. If vbus discharges to vsafe0v sooner, then,
transition to unattached state
happens right away.
Also, while in SNK_READY, when auto discharge is enabled, drive
disconnect based on vbus turning off instead of Rp disappearing on
CC pins. Rp disappearing on CC pins is almost instanteous compared
to vbus decay.
Sink detach:
[ 541.703058] CC1: 3 -> 0, CC2: 0 -> 0 [state SNK_READY, polarity 0, disconnected]
[ 541.703331] Setting voltage/current limit 5000 mV 0 mA
[ 541.727235] VBUS on
[ 541.749650] VBUS off
[ 541.749653] pending state change SNK_READY -> SNK_UNATTACHED @ 650 ms [rev3 NONE_AMS]
[ 541.749944] VBUS VSAFE0V
[ 541.749945] state change SNK_READY -> SNK_UNATTACHED [rev3 NONE_AMS]
[ 541.750806] Disable vbus discharge ret:0
[ 541.907345] Start toggling
[ 541.922799] CC1: 0 -> 0, CC2: 0 -> 0 [state TOGGLING, polarity 0, disconnected]
Source detach:
[ 2555.310414] state change SRC_SEND_CAPABILITIES -> SRC_READY [rev3 POWER_NEGOTIATION]
[ 2555.310675] AMS POWER_NEGOTIATION finished
[ 2555.310679] cc:=3
[ 2593.645886] CC1: 0 -> 0, CC2: 2 -> 0 [state SRC_READY, polarity 1, disconnected]
[ 2593.645919] pending state change SRC_READY -> SNK_UNATTACHED @ 650 ms [rev3 NONE_AMS]
[ 2593.648419] VBUS off
[ 2593.648960] VBUS VSAFE0V
[ 2593.648965] state change SRC_READY -> SNK_UNATTACHED [rev3 NONE_AMS]
[ 2593.649962] Disable vbus discharge ret:0
[ 2593.890322] Start toggling
[ 2593.925663] CC1: 0 -> 0, CC2: 0 -> 0 [state TOGGLING, polarity 0,
Fixes: f321a02cae ("usb: typec: tcpm: Implement enabling Auto Discharge disconnect support")
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Reviewed-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Badhri Jagan Sridharan <badhri@google.com>
Link: https://lore.kernel.org/r/20210225101104.1680697-1-badhri@google.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Pull rdma fixes from Jason Gunthorpe:
"Nothing special here, though Bob's regression fixes for rxe would have
made it before the rc cycle had there not been such strong winter
weather!
- Fix corner cases in the rxe reference counting cleanup that are
causing regressions in blktests for SRP
- Two kdoc fixes so W=1 is clean
- Missing error return in error unwind for mlx5
- Wrong lock type nesting in IB CM"
* tag 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/rdma/rdma:
RDMA/rxe: Fix errant WARN_ONCE in rxe_completer()
RDMA/rxe: Fix extra deref in rxe_rcv_mcast_pkt()
RDMA/rxe: Fix missed IB reference counting in loopback
RDMA/uverbs: Fix kernel-doc warning of _uverbs_alloc
RDMA/mlx5: Set correct kernel-doc identifier
IB/mlx5: Add missing error code
RDMA/rxe: Fix missing kconfig dependency on CRYPTO
RDMA/cm: Fix IRQ restore in ib_send_cm_sidr_rep
Pull gcc-plugins fixes from Kees Cook:
"Tiny gcc-plugin fixes for v5.12-rc2. These issues are small but have
been reported a couple times now by static analyzers, so best to get
them fixed to reduce the noise. :)
- Fix coding style issues (Jason Yan)"
* tag 'gcc-plugins-v5.12-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/kees/linux:
gcc-plugins: latent_entropy: remove unneeded semicolon
gcc-plugins: structleak: remove unneeded variable 'ret'
Pull device mapper fixes from Mike Snitzer:
"Fix DM verity target's optional Forward Error Correction (FEC) for
Reed-Solomon roots that are unaligned to block size"
* tag 'for-5.12/dm-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/device-mapper/linux-dm:
dm verity: fix FEC for RS roots unaligned to block size
dm bufio: subtract the number of initial sectors in dm_bufio_get_device_size
Pull block fixes from Jens Axboe:
- NVMe fixes:
- more device quirks (Julian Einwag, Zoltán Böszörményi, Pascal
Terjan)
- fix a hwmon error return (Daniel Wagner)
- fix the keep alive timeout initialization (Martin George)
- ensure the model_number can't be changed on a used subsystem
(Max Gurtovoy)
- rsxx missing -EFAULT on copy_to_user() failure (Dan)
- rsxx remove unused linux.h include (Tian)
- kill unused RQF_SORTED (Jean)
- updated outdated BFQ comments (Joseph)
- revert work-around commit for bd_size_lock, since we removed the
offending user in this merge window (Damien)
* tag 'block-5.12-2021-03-05' of git://git.kernel.dk/linux-block:
nvmet: model_number must be immutable once set
nvme-fabrics: fix kato initialization
nvme-hwmon: Return error code when registration fails
nvme-pci: add quirks for Lexar 256GB SSD
nvme-pci: mark Kingston SKC2000 as not supporting the deepest power state
nvme-pci: mark Seagate Nytro XM1440 as QUIRK_NO_NS_DESC_LIST.
rsxx: Return -EFAULT if copy_to_user() fails
block/bfq: update comments and default value in docs for fifo_expire
rsxx: remove unused including <linux/version.h>
block: Drop leftover references to RQF_SORTED
block: revert "block: fix bd_size_lock use"
